Blinky¶

Overview¶

The Blinky sample blinks an LED forever using the GPIO API.

The source code shows how to:

1. Get a pin specification from the devicetree as a gpio_dt_spec

2. Configure the GPIO pin as an output

3. Toggle the pin forever

Requirements¶

Before you start, check that you have the required hardware and software:

• 1x nRF52840 Connect Kit
• 1x USB-C Cable
• A computer running macOS, Linux, or Windows 7 or newer

Building the sample¶

Before you start building, remember to set up the environment first.

Use the following steps to build the Blinky sample on the command line.

1. Open a terminal window.

2. Go to my-workspace/ncs-playground directory created in the Setting up the environment section.

   1	cd my-workspace/ncs-playground

3. Build the sample using the west command, specifying the board (following the -b option) as connectkit_nrf52840:

   1	west build -p always -b connectkit_nrf52840 samples/blinky

   Tip

   The -p always option forces a pristine build, and is recommended for new users. Users may also use the -p auto option, which will use heuristics to determine if a pristine build is required, such as when building another sample.

4. After running the west build command, the build files can be found in build/zephyr.

Flashing the firmware¶

The sample is designed to work with the UF2 Bootloader, so that you can easily flash the sample using the UF2 Bootloader. The firmware can be found in build/zephyr with the name zephyr.uf2.

To flash the firmware, complete the following steps:

1. Push and hold the USER button and plug your board into the USB port of your computer. Release the USER button after your board is connected. The RGB LED turns green.

2. It will mount as a Mass Storage Device called UF2BOOT.

3. Drag and drop zephyr.uf2 onto the UF2BOOT volume. The RGB LED blinks red fast during flashing.

4. Reset the board and the sample will start running.

Testing¶

After flashing the firmware to your board, the Green LED starts to blink.