USB HID Mouse¶

Overview¶

The USB HID Mouse sample demonstrates the use of a USB Human Interface Device (HID) driver by the Zephyr project. This very simple driver enumerates a board with a button into a mouse that has a left mouse button and optionally (depending on the number of buttons on the board) a right mouse button, X-axis movement, and Y-axis movement. If the USB peripheral driver supports remote wakeup feature, wakeup request will be performed on every button click if the bus is in suspended state.

Requirements¶

Before you start, check that you have the required hardware and software:

• 1x nRF52840 Connect Kit
• 1x USB-C Cable
• A computer running macOS, Linux, or Windows 7 or newer

Building the sample¶

Before you start building, remember to set up the environment first.

Use the following steps to build the USB HID Mouse sample on the command line.

1. Open a terminal window.

2. Go to my-workspace/ncs-playground directory created in the Setting up the environment section.

   1	cd my-workspace/ncs-playground

3. Build the sample using the west command, specifying the board (following the -b option) as connectkit_nrf52840:

   1	west build -p always -b connectkit_nrf52840 samples/usb/hid-mouse

   Tip

   The -p always option forces a pristine build, and is recommended for new users. Users may also use the -p auto option, which will use heuristics to determine if a pristine build is required, such as when building another sample.

4. After running the west build command, the build files can be found in build/zephyr.

Flashing the firmware¶

The sample is designed to work with the UF2 Bootloader, so that you can easily flash the sample using the UF2 Bootloader. The firmware can be found in build/zephyr with the name zephyr.uf2.

To flash the firmware, complete the following steps:

1. Push and hold the USER button and plug your board into the USB port of your computer. Release the USER button after your board is connected. The RGB LED turns green.

2. It will mount as a Mass Storage Device called UF2BOOT.

3. Drag and drop zephyr.uf2 onto the UF2BOOT volume. The RGB LED blinks red fast during flashing.

4. Reset the board and the sample will start running.

Testing¶

After flashing the firmware to your board, complete the following steps to test it:

1. Connect nRF52840 Connect Kit to your computer using the USB-C Cable.
2. The board will be detected as a HID mouse named Zephyr HID mouse sample.
3. Press USER button on the board. Observe that a left mouse click is activated.